Аннотации:
The paper presents the results of the study of the proposed type of variable profile piles. The proposed type of piles is reinforced concrete driven piles segmented in length. Each subsequent section has a ra-dial displacement along the axis of symmetry relative to the previous section. The positive effect of the performance of the proposed pile is to change the nature of the lateral contact of the pile with the soil, and to increase the drag of the soil. The conducted research is aimed at solving the problem related to the relatively low bearing capacity of traditional square section piles. The research was carried out by the method of model tests of piles on a test bench (tray) at a scale of 1:10. The tests were performed for variant pile types in comparison with a standard square section prismatic pile. The adopted dimensions of the pile model allow the use of this tray without the influence of its boundary conditions on the stress-strain state of the soil. A total of 42 tests were performed, 3 tests for each type of piles compared. Evaluation of pile bearing capacity was performed by static loading of pile models with vertical indentation load until failure. According to the results of the investigations, the resistance values of the compared pile types in the soil were obtained, as well as the dependence of bearing capacity changes on the section dimensions and on the rotation angle. According to the results, the optimal pile solution was selected. The bearing capacity of the proposed optimal pile solution exceeds the bearing capacity of the standard driven pile by 22 %. The results obtained allow us to conclude about the influence of the technological solution of the proposed pile type on its serviceability in soil conditions © (2024), (Technology Center). All Rights Reserved.
